Save cost by reconditioning your batteries instead of replacing them, at a fraction of the price, with this proven method used by countless thousands in over 120 countries globally! Having a portable jump starter like
Testing the efficacy of your desulfator: The best way to test the efficacy of our desulfators is to have the battery tested for CCA (Cold Cranking Amps) and milli Ohms (mΩ) before installation. You can either
Ever wondered how a lead-acid battery’s charge duration is calculated? This is the formula to calculate the charge duration: Battery Charge Time = Battery Capacity / Charging CurrentTime (Hours) = Amp Hours / Amps So
When the active material in the plates of a battery can no longer sustain a discharge current, a battery “dies”. Normally a car (or starting) battery “ages” as the active positive plate material sheds (or
“Up to 84% of batteries fail prematurely from sulfation” – Battery Council International Lead sulfation actually starts when you remove the charging voltage from a fully charged lead-acid battery. Though the lead sulfate crystals are converted back
WARNING: Always wear protective spectacles whenever dealing with car batteries. If done incorrectly, jumping a dead battery can be dangerous and financially risky. These procedures are ONLY for vehicles are that are both negatively grounded
Chances are that your battery has some permanent sulfation, if it will not “take” or “hold” a charge and exhibits one or more of the following conditions: If your wet (flooded) Standard (Sb/Sb) or wet (flooded)
Unlike batteries used to start engines, deep cycle batteries are designed to store power. They have fewer and thicker lead plates as compared to starter batteries. Starter batteries are designed to provide a sudden surge
Due to its low cost, hydrometers are often used to measure the specific gravity or the concentration of the sulfuric acid in a battery. The specific gravity measurement reflects the state of charge of a